Trend Contractor Two Piece Hinge Jig

CODE: H/JIG/A

Features

• It is easy to use with minimal setting-up time, completing the job both accurately & quickly.
• Used on-site & in joinery shops to increase productivity with excellent results.
• Four apertures for fire door requirements.
• No need for marking out in the conventional way.
• Quick & simple to set-up as the hinge is used as the pattern.
• Clean & accurate recesses are achieved every time. Suitable for timber based doors & square butt hinges.
• Use with a light duty router with 1/4 inch collet.
• Long reach router cutter required, 12mm diameter with 70mm overall length.
• Angled position slots to prevent creep.
• Unibase may be needed.
• Patent No. GB2285410.
• T4EK router requires a ref. UNIBASE or special guide bush ref. GB/T4/160.

• Hinge sizes possible        
• Length min. - 2 5/8" (67 mm)    
• Length max. - 5" (127 mm)    
• Width min. - 3/8" (9.5 mm)    
• Width max. - 1 3/8" (35 mm)    
• Door sizes possible        
• Height min. - 6' 5" (1955 mm)    
• Height max. - 6' 10" (2100 mm)    
• Thickness min. - 5/8" (16 mm)    

• 4 x Apertures
• 2 x Bradawls with spacer
• 1 x 16mm guide bush
• 1 x T-Handle hex key
• 1 x 4mm spacing gauge
• 1 x Fabric storage case